Other Network Architecture Subjects

Why after a backup ACLServer do no restart?I try to backup ACLM data with this commands:%NMSROOT%\bin\pdterm AclmServer%NMSROOT%\bin\perl %NMSROOT%\bin\aclmbackup.pl %NMSROOT%\bin\perl %NMSROOT%\bin\aclmbackup.pl <c:\batch\aclpath.txt >>c:\batch\log...

Hi! I'm implementing diffserv in a 7200 cisco router with IOS12.2(2)T. I've configured the classes and policy-maps as described in the paper "Implementing Diffserv for End-to-End Quality of Service Overview". This configuration is done with a wrapper...

Dear Friends,I have a VWIC-2MFT-T1= CARD, what I would like to do is share the internet traffic on the 2 ports of the vwic card.Things that I have:Both the T1's are coming from the same ISP. T1 have different network address and subnet mask.Please le...

Some of our sites have dual PVCs pointing to two different FR T1's on our head-end router, the PVC's have the same port speed, CIR, and the bandwidth command is set to the same for both PVC's, so from EIGRP the paths are equal. My question is how do...

Hi,I've configured a simple hub and spoke Frame Relay networks with standard physical interface (not sub-interfaces) and with Frame Relay Inverse arp enabled and I'v tried to configure a routing protocol, ospf first and eigrp last. I've noted that b...

Hi,We have frame relay network. I will like to know if thre is a way to tell how long a physical interface (in this case a serial int) has been down by checking on the router.I s there a way to tell or what to look at by doing for example a show int...

Can I and How can I configure a Frame Relay Interface using DLCI number auto discovery?Because I can not get the correct DLCI number.

I have an ATM link between two sites of 34mb. I have an Ethernet interface on Router B that is recieving so much traffic that it is causing the router to crash. Is there a way that I can throttle this interface so that it only allows x amount of traf...

We have a star network with 1751s at edges and 3662 at center. the edge routers connect to central router with 64kbps link. ISDN is provided for backup.some of the links show heavy CRC errors, due to which the application times out. But as the link i...

hi,I want to know the different routers which are being used to implement MPLS and how MPLS has been implemented in Cisco's routers.thanks,Niveditha

Hi,During sniffing my network, I encountered a lot of SNAP frames with oui:00-00-0c, pid:01-0b, destination address: 01-00-0c-cc-cc-cd. I could not find any document about how to decode this frame. Has anyone got any decent list for these multicast f...

How can i update the cat5000 supervisor from NMP2.1 to version 4.1 or above.I tried this for many times, it seems only work withc5009.nmp.

Hi,How can i find out the IP & MAC address of the client plug into a 3500XL port?

I was NOT able to launch CiscoView. I get a message popup asking me to PLEASE GRANT PERMISSION TO LUANCH CISCO VIEW AND LAUNCH AGAIN. Verified that its not a new installation. Tried basic troubleshooting like creating a temprovary account and asked ...

Hi.I have a 1710 and 2621 both with private addressed networks being encryped with single DES. Traffic goes from 1710 to 2621 fine. The other way it does not. I also have a 1720 setup with the 1710 that works fine both ways. A traceroute from a h...