Other Network Architecture Subjects

I have try to interconnect an Catalyst 3500 switch with an 1000Sx GBIC with an Intel 510 T switch with an 1000Sx insert, but this doesnt work ( the link never mount ).Note : I'm sure the two equipement work.Does someboby have an idea.Thanks for your ...

I need to get Frame Relay queue lenght for a DLCI via snmp.It could be octects or packets, does any of you know the variable or the OID.Thanks in advance.Pablo

I have set the discovery schedule, for the ANI Server, on CW2K to run everyday at 5am.I've just recently added some new switches and routers to my network.I want ANI to find them now. I don't want to wait until 5am tomorrow. That way I can sync ANI...

can i know when i see ip address in the internetto which AS its belonging ?what is the relation between them ?where can i see the "map" of the AS in the internet ?and other information about AS in the internet .thanks you very much:)

I have a Cisco 3640 and an ACS 3.0. I want that when the remote client connects he load Primary DNS and Secondary DNS. Are there any way to do that??Thank you.

I want to make sure I have not overlooked a potential looping issue. I have a server with 4 NIC's where I have port channeled "on" each pair of connections creating 2 port channels. All the ports are on the same VLAN and going to the same switch. Is ...

What excatly does nonblocking mean? is there a document I could refer to?

We have a situation where we are using several remote 3524 switches, which need to be connected to our core Switches (5505s)some distance away in another building. We have fibre links to and from these locations, but our 5505s only have 10BaseFL conn...

HI, I have a setup where 3524s are used as access switch and intervlan routing is happening in 4908G-L3 switch. I have to restrict some users for internet access. I can do this by confiuring access lists. But if the users change the ip address to a ...

I have a 2610 router with a NM-1E2W.How many E1 can I connect in total using the twoWIC ports and the one AIM?ThanksFlorian

Hi Guys, We are having two equal cost paths and facing problem while configuring ip multicast with load balancing.We are using 2610 and 1750 series routers at diffrent ends. Thanks in advance.Pushpender

We would be using a Catalyst 3508 at the MDF and have it connected to a Catalyst 3548 via Cat-5e cable. This set-up will be for interconnecting two buildings and we plan implement copper solutions via a WS-G5482 Copper GBIC. I was wondering, if thi...

The whole thing is down now. I have a Rommon sign. No idea. I just want to install the ios. Can't believe its this tough. So I can't actually get the PC to talk to the router over ethernet, just through the console. I have a cross-over from networkca...

Hi,I've a 3600 series router... whenever router is switched on, it boots from rom, instead of the flash.I've checked the config-register, and saved the proper value in the startup-config(to boot from the Flash)... still next time it boots from the ro...

I am getting multiple messages on couple of Catalyst 4000 switches. These messages show up on the CiscoWorks management station. Does anyone know what they mean?InCharge Domain : DFM Switch 172.22.1.100 PerformanceException - System is experiencing...