With ciscoworks 2000 , can I monitor cpu utilization of router and catalyst switch like solarwind ?With ciscoworks 2000 , can I monitor port traffic flow of router's interface like MRTG?thanks very much!
Might anyone be able to provide me with clues on how to create a job that would go into each fastethernet port 0/1 through 0/48 (on3500XL) and execute the same command --- specifically "spanning-tree portfast"? Is there an easier way than using CW2K...
Hello,well i am facing some troubles in configuring frame relay.i have a cisco 2621 router connected to a frame relay cloud. and i do have 2 branch offices with 1750 routers. For each connection i have an independat DLCI number and network address. I...
Can anyone tell me if a GBIC model WS-G5482 will work in a Catalyst 6000 series switch? We have a GBIC model blade inserted into our 6000 and currently use some Fiber GBICs in it to run uplinks to our core network but would also love to be able to ad...
Basically, this router connects to the Internet, and a private corporate network. It brings up links correctly, and routes traffic correctly, even NAT seems to work just fine.My problem is that when the dialer idle-timeout expires, it hangs up. Int...
hello,in the router 3662 IOS 12.2(1) config for dns looks as follows:...ip domain-list town1.company.netip domain-list town2.company.netip name-server 10.2.2.32...I do not specify ip domain-name option. When configured like this IOS NEVER resolves an...
Hi, Is there a way to connect two mgx 8230 back to back with the oc-3 pxm-1 port?I'm trying to pass e1 traffic from one CESM E1 to other. This is the lab setup:e1--cesm-mgx8230-pxm1 --- pxm1-mgx8230--cesm--e1Thank you in advance.
Hello everyoneI have a network with 4 VLANS. The switches are 2980s and 3640 router routing my VLANS. When a user accesses a server on his same subnet all is good. However, when a user from a different VLAN from the server accesses the same file i...
Hello,I'm going to have to design a network with the following caracteristics:- 700 users- 20 servers- 2 buildings linked through an optic fiber link my problem is that ther is no real group among the 700 users, and then there is no logical reason to...
HiWe have a 3620 router with a fast ethernet card.the IOS version is 12.0(13)When we add the ATM OC3 Network Module NM-1A-OC3MM,our router doesn't recognize it.The EN Led flashes once and then goes off.We have tried 2 different cards with 2 different...
I am about to network 4 different buildings on different parts of the state. What is the most cost effective solution? Frame Relay etc.....and which routers would I need.
I have a 827 router going out to the inter net via a dsl line. I can get to the pop3 server but can not send mail to the smtp server. I was told that I should open port 25. I am not sure how to do that. This is the 1st time I am working with a router...
