Other Network Architecture Subjects

WCCP on Cisco 2600 router

Im trying to catch data from the internet with a Sun T1 with Inktomi as the caching software, it works with WCCP2 and the connecction is via a 2600 router with the wccp2 enabled and the redirect out in the interfece directly connected to the internet...

Cannot access my 7204 router via telnet and console

In need urgent help, I cannot establish a connection into my 7204 router by telnet and through the console, there 's a message reading MALLOCFAIL- memory allocation 0f 128975 bytes failed freom 0x600c6680

Slow Telnet session on a router

HelloI'm looking for help on an issue with a router. It seems I have a very slow telnet session to a particular router. However, all other devices on the smae net work just fine. Any thoughts??MS

How to use HSRP w/out ordering another T1 for my WAN connection?

I am trying to use HSRP on two of my 7206 routers for the WAN connection, but I dont wanna have to order another T1 line just so that I could HSRP. Is there a way that I can use my one T1 line on both routers...i.e with some sort of "y" or a split...

what is the maximum memory recommended for a 7204 router

I have exhausted the 32meg memory of my 7204 router to 26m/6m, what is the max memory I can upgrade to.

Switching

What is MLS

linux 2501 setup

I'm trying to connect through a serial port to a 2501 I got to help me get my ccna.... but I'm getting a input output error in minicom. Here are my settings whats wrong...Serial Device: /dev/ttys1Lockfile Location: /var/lockCallin program: Callout P...

DHCP problem on Catalyst 5000

We have a very strange problem. At the customer site, when somebody wants to get an ip address via DHCP, it is no problem. When somebodyelse from another site wants to log in they don't get an ip address. They have to do a release and a renew to get ...

Solution Reqd. for DHCP Server on Cisco Catalyst 6500

We need to define DHCP Pool for each VLAN on Catalyst 6509 Switch. On Access Layer, we are using Catalyst 3548's switch. Users are coming to access layer to be a part of departmental VLAN's. We want they must take IP from their VLAN. How this can be...

Trunking a 6500 running Native IOS to 5500 running CATOS

Has anyone out their expierenced problems with spaning-tree while trying to create an ISL trunk to a 5500 from a 6500 running Native IOS??? I have 2 6500 running in HSRP talking via a trunked port-channel. They work and talk fine until I try to trunk...

Dialin modems in cisco 3640

I am a small ISP and I have an access server, a cisco 3640 with a 16 modems module, in a remote dialin session the modem ends up in an already existing session initiated, the end time and the initiated session is varilbe the users may be conncted for...

ISDN dialer profiles

Sir/Madam,I am trying to make ISDN bri interface of Cisco 3660 to run different dialer profiles , so can connect to different locations according to importance.I have seen sample conf on Cisco site, its pretty useful, Pls let me where to configure Di...

Cisco 2610 Configuration

I need to configure a Cisco2610 with 8 BRI isdn interface card with eight complete separate routes.Cost of line activation is very critical. I do have 8 Cisco 801 in the other ends and they are working fine. IOS is 12.0(7)T.I relly need some help wit...

Load Sharing

Trying to find out on what series of routers would be the better choice to run load sharing T1's on for approximately 300 clients and what expansion cards are needed for them. Cisco 3600????

dsl

how is the dsl connection proforming

Other Network Architecture Subjects

Forum Posts

WCCP on Cisco 2600 router

Cannot access my 7204 router via telnet and console

Slow Telnet session on a router

How to use HSRP w/out ordering another T1 for my WAN connection?

what is the maximum memory recommended for a 7204 router

Switching

linux 2501 setup

DHCP problem on Catalyst 5000

Solution Reqd. for DHCP Server on Cisco Catalyst 6500

Trunking a 6500 running Native IOS to 5500 running CATOS

Dialin modems in cisco 3640

ISDN dialer profiles

Cisco 2610 Configuration

Load Sharing

dsl

Get ready! Great things are coming to Cisco Community

Have your wish for humanity broadcast into space by George Takei!

Host unable to access remote Host from behind ASA / Router

Re: Cisco device discovery

Re: help with log in router cisco ASR1001-X

Switching

Re: Ppoe automatic default route. &IP address

Routed port versus transit vlan for intervlan routing

Network card interface lights

Real multicast uses on the public internet

reboot after short power outage

CBS350-48Xt-4X missing UDP Relay and IP helper-address