We are experiencing an unusual amount of damage to our Ethernet ports at one particular site. The site has a high lighting potential due to it's open and elevated location. However, the data to the port is brought in to the building over fiber into a...
Hi,How I can monitor the Vlan utilization ?for the normal Ethernet Interface I use SNMP trap to collect the InOctet and OutOctet and calculate the Utilization, but with Vlan I can not find a way ??Do any one know a way with SNMP ? or other way?I want...
we have a Cisco 805. LAN has 192.168 address block, and we have a few global (routable) IPs. Each routable IP is mapped to a web server on the internal network using the following method:ip nat inside source static tcp 192.168.*.* 80 routable_ip port...
I have a router Cisco 3620, IOS Version 11.2(16)P, and I don't know enable's password.My PC's OS is WinNT 4.0 and I pressed BREAK on the terminal keyboard but the router didn't go to ROMMON.Thks.
Can anyone out there tell me where I can find more information about the native IOS??? We are running a Catalyst 6500's and have just completed the conversion and are finding TAC itself is not that helpful with the native IOS. I am looking for a good...
I just got a 7206 with the following configuration:2 1-Fast Ethernet portadaptors 1 4-Ethernet portadaptor1 4-Serial portadaptor48MB RAM 8 MB RAMand i get the following message as soon as i boot it up...and the message keep on repeating itself and no...
I am configuring a PPP dial-up connection using a 2520 and a 2621. the 2520 is connected to the async modem. the 2621 has 2 ethernet ports, the one is connected to the 2520 and the other one is connected to our main network. after dial-up, the remote...
Could someone help explain why I keep seeing OSPF interface retransmit messages in my gateway router logs. I run a bunch of foundry routers on my network and have verified that the MTU is set to 1500.Please help....Thanks
Hi all, I am wanting some help with bridging. I have two Cisco 2600's with a 1meg leased line in between, i am using 15 channels of primary ISDN as a backup. there is a system called a tandem at each end of the leased line. these two pieces of kit ne...
Hi! I have a router 760, and i need to know the users connected to the router or the users u make the calls.Can some one help me?Thanks.Pedro Guerra from Portugal.
I want to implement traffic shaping in a Frame Relay network (partially meshed topology) using layer 3 protocols as a priority factor, what would be the best queuing method?, also, could anyone give me a good reference?, sample?.Thanks!Xarold
when configuring a 2500 series router e0 interface with with three different IP subinterfaces and one network Novell IPX, could u include the novell configurations on the e0 interface as a secondary config? Or do I need to add another subinterface?A...
