Other Network Architecture Subjects

I thought all cards were could be installed while the 6509 was running but this caused a reload. Any ideas?

What is the best method to connect 2 switches to 1 router when both switches run the same VLANs? Method A - Enable etherchannel on the router and connect both switches to the router. Method B -Connect the two switches together and then connect one of...

GOOD DAY!Could some body;tell me what is this error in my 6509?Have a look to this error?00:16:53: %C6KERRDETECT-SP-2-LPBKFAIL: The in-band loopback test between switchprocessor and route processor failed, count:4000:16:53: SP: SP-RP Ping Test[1]: CP...

We have a pair of cat6509 switches connected together via fibre (ZX GBIC) Gigabit links. Gig port 1/1 & 1/2 on sw01 (6509) is connected to Gig port 1/1 & 1/2 on sw02 (6509). They are Dot1Q trunked and Etherchannelled.Sw01 config:module 1 : 2-port ...

Hi AllI Configure a 2950 switch to enable guest to browse through BBSM 5.3 The guest can browse when connect to the switch but i cannot see the switch active in the BBSM Server.How can make the switch active?

How can we check what Kind of Traffic flowing on the interface e.g HHTP,POP or is there any software to check the traffic how much traffic each system is using

We use AutoQoS to trust the CoS value of incoming frames from IP Phones connected to access layer switches. We are now using VT Advantage and want to ensure that the video traffic generated by the attached PC has its DSCP value honoured (the PC-gener...

Am I correct in saying that a 2 meg line would mean 2 megabytes ? and would how would i meausure the bandwidth, would i measure it in megabytes or megabits ?thanks

Hi, I would like to create 2 user groups (A & B) in my ACS server such that Users in A group are able to access switches and routers only where as Users in B group are able to access only MGXs. Group A users should nt access MGX and Group B users are...

Hi All,To assign an IP address to the management VLAN (default is VLAN 1)Cmd are:Switch(config)# interface vlan vlan-idSwitch(config-if)# ip address ip-address netmaskSwitch(config-if)# ip default-gateway ip-addressSwitch(config-if)# no shutdown1.I c...

We have a customer who has their edge switch connected to two core switches, between the two core switches we have configured an Etherchannel. We have used Spanning Tree to block at the edge, therefore one core switch is the root for even vlans and t...

HiI have to install a new version on a AP and i just downloaded a .tar file from Cisco.My question is, can i boot directly from that tar file?I never tryied this and before doing something wrong i want to be sure it will work. I read somewhere that m...

I am trying to set up a voice and data vlan, each with a seperate IP range. The default VLAN (1) is the data Vlan, but when I enter an IP address under the voice Vlan, the primary Vlan shuts down.Is it possible to have two IP addresses on a 2950? If ...

Hi All, I have a Cisco 2610 Router having IOS version 12.2(29a). I want to run isis protocol on this router but unable to do this. When I enter " router isis " command in configuration mode then the prompt does not change to Router(config-router)# mo...