Other Network Architecture Subjects

HiI have to install a new version on a AP and i just downloaded a .tar file from Cisco.My question is, can i boot directly from that tar file?I never tryied this and before doing something wrong i want to be sure it will work. I read somewhere that m...

I am trying to set up a voice and data vlan, each with a seperate IP range. The default VLAN (1) is the data Vlan, but when I enter an IP address under the voice Vlan, the primary Vlan shuts down.Is it possible to have two IP addresses on a 2950? If ...

Hi All, I have a Cisco 2610 Router having IOS version 12.2(29a). I want to run isis protocol on this router but unable to do this. When I enter " router isis " command in configuration mode then the prompt does not change to Router(config-router)# mo...

Can some one give Links relted to STP and RSTP where i could learn from the study documents

Hello Friends,I have Six Catalyst 2955 Switches on which RSTP is running (Just "spanning-tree mode rapid-pvst" runs)...now I want to ask what are the other standard things (like IGMP snooping etc) needed to configure switches to improve performance (...

hi I need to rate limit the traffic on each port I've also tried policing but when its applied to the specific interface using "service-policy output xxxx", i get the error "Warning: Assigning a policy map to the output side of an interface not suppo...

WS-C6506 Software, Version NmpSW: 6.1(1b)Copyright (c) 1995-2000 by Cisco SystemsNMP S/W compiled on Nov 9 2000, 22:11:25System Bootstrap Version: 5.3(1)Hardware Version: 3.0 Model: WS-C6506 Serial #: TBA05061441Mod Port Model ...

I have three three routers connected in a straight line. For sake of simplicity I'll call them my left, --Left---eth----Middle--serial---Right-- Left runs only RIPv2, Middle runs OSPF and RIPv2 and mutually redistributes bewteen the two, and Right r...

Hi,i could able to ping 10.2.1.0 & ofcourse broadcast can ping 10.2.1.255. so is it normal r something probz went wrong like looping?

Hi,Newbie here... 2 questions:1. Say you do "sh access-list 109", and see something like this:..permit tcp any any established..permit udp any any eq bootps (116125 matches)..permit icmp any any (782 matches)..permit udp 10.0.0.0 0.255.255.255 10.0....

Hi!i have 6509 SUP1-2GE.THIS BOX Run IOS"c6sup11-dsv-mz.121-20.E2".THIS BOx with this IOS support GLBP?& THIS IOS Contain bugs or not?if so how can update this IOS?ALSO WHICH IOS I NEED TO RUN GLBP In this box?10xs for ur help!Ali

How does GBIC and STP work ?For trunks,I know that when you connect 2 switches together via regular ports you need 2 ports connected on both switches via crossover. Then STP blocks one of the ports on the non-root bridge.I also know that you can setu...

is it possible to dynamically nat between rfc1918 networks where the host portion of the ip address is maintained during the translations? I've looked at the cco pages for nat but don't see this detailed. since ios and pix are converging, and i kn...