Other Network Architecture Subjects

Hi to all,i would like to send the output of a single command to an email address so i have created a simple script you can see below. The email is successfully sent to the recipient with the correct subject but the body is empty. +++++++++++++++++++...

Hi, Please help to configure inter vlan in SG550x switch. and i have tried but it not supporting please share the step by step configuration documents for this model switch.  Thanks in Advance.. Regards..Umesh Sharma | +91 9007743324 

Hello, I am attempting to create a Python script that will establish an SSH connection to and restart our CUCM servers. If I can get this working it will prevent me from having to sign on to 20 + servers and issue the command manually. The below scri...

Hello dear all.I've been trying to find out information about the End of Life and End of Support of some CISCO devices.Could anyone help confirm the following informationVendorDevice TypeSoftwareEOLEOL OK or NOK?EOSpEOSp OK or NOK?CiscoSwitch12.2(53r...

Hey Guys. I really need your help on this one.I have a rather advanced traffic shaping scenarie that i would like to know if it's possible, and feel free to do a POC of the policy map if it sounds fun ; ).So, the hardware is ASR1001-X with ofc IOS-XE...

Cisco,I have been waiting a long time for a few different visio stencils that were never released even near the end of the product lifecycle and had to make my own simple stencils. I need an update to the ISR1K router stencils because some of the mod...

I am trying to use the interface range command on a 4500 switch and it is refusing to take it. I would able to use the command just a couple months ago but I dont remember what I exactly typed in. I tried typing:interface range gig 5/1 - 48,gig 6/1 -...

Hi, I've been doing my research, watching vids on MP-BGP EVPN. All the documentation I have found thus far is referring to the Spine/Leaf design and config. I'm looking to L2 connect DCs over L3 (using a 9k in one DC and CSR100v in the other DC) by r...

I've attached a diagram to this discussion. Would a design like this be used in the real world? R1 and R2 are running HSRP. The issue I'm concerned about with the design is SW2. The diagram shows redundancy with the routers, but then SW2 becomes a si...

I am using the PWR-C1-715WAC-p in the 9300 switches.  Can i supply this PS with 240 VAC line to line or is it rated for 240VAC line to neutral? Which power chord should I use for 240VAC Line to lin 

Hi,My question is: Why is point-to-point topology configured in loopback? Is it because of the fact that loopback never goes down unless it is manually shut down or if the router crashes, or, is there/are there another explanation(s). Thanks,joe.