Hi there,I am new here but I wondered if any could tell me whether a Catalyst 6500 switch with a WS-X6K-SUP2-2GE engine and WS-F6K-MSFC2 switch feature card will support a WS-X6548-GE-TX 10/100/1000 ethernet module? The switch is installed with CATOS...
i have to upgrade the image of a 6506 having (2) SUP-720-3BXL & (2) 10G line cardscurrently it is booting with CAT OS i have to upgrade the image to IOS.does any one have the similar situtation?regards,Haris
I have the following problem: I was changing to the IP direction Management of switch catalyst 6509, and forgets to clear the authentication to Tacas.Trying to solve the problem when attempt to connect by console, I have access it is to the MSFC and...
I know the supervisor has to be in slot 5 or 6, 6 is usually the standby. does it matter if we are never going to have a redundant sup if we put our primary in slot 6 and run off of that normally and use slot 5 as an everyday slot?
Hi,I would appreciate some advise on the following:1) If 2 PCs have the same IP address on the network, what would be the impact? 2) If a PC is having the same IP address as the gateway, what would be the impact? How do we track on the network if it ...
I have a Cat3550. When I try to save the config, show me this message: % Warning: Saving this config to nvram may corrupt any network management or security files stored at the end of nvram. Continue? [no]: % Configuration buffer full, can't add comm...
HiI have a big problem that hope someone can get me a answer on.Our network is small one only one SBS 2003 server and a 1841 vpn router, its configured to give VPN user a IP number from a internal pool with different ip range from the local network.S...
I've been working on a Cat6509 (also the VTP server) and I started adding vlans in global config mode. When I type "sho vlan" I can see all of the vlans I have added so far. When I look at the running-config/startup-config I show no signs of the vl...
Hi all,I have to design the LAN infrastructure for a new building. I'm familiar with these sorts of designs but the requirement is insane. I know what sort of design I want to use but I don't know of any hardware which would cope with what needs to b...
Hi,is it possible to install cat6500 module WS-X6416-GBIC on Cat4000? and cat4000 module WS-X4148-RJ on cat6500?I don't think so? Please give some advise.Thanks,Christina
Hi,I think most cat4000 & cat6500 modules are hot swappable. Hence, WS-X6416-GBIC & WS-X4148-RJ are hot swappable.I would appreciate if someone can advise on this.Thanks.Christina
