Hi, I recently installed an SAF Technika microwave system that has links which are 2+0 (2 parallel microwave links). Each link is 450 Mbps and one side connects to a IE-5000 and the other side to an IE-4000. As long as the bandwidth is 400 Mbps or...
Forum Posts
Resolved! IE-5000 & IP Services
I am building a microwave hub on top of a mountain for 6 1GB wireless links. I am choosing the IE-5000 because I am not 100% confident in my temperature control. I will need layer 3 switching, so I want to buy the IP Services software upgrade. 1....
Hey All, I have seen that you are unable to apply a Crypto-Map to a Tunnel interface or Port-Channel, so I am looking for alternative solutions. I have a single router terminating IKEv2 tunnels with 1 Public / 1 Private Interface. I am looking to f...
How do I get a user id and password to have access to have some cisco tools like SDM ?thank you
Hello community,I hope im correct here.im fairly new to the network field, however i would like to ask something.Im currently working as a working student at a company and have the task for designing a method to autoconfiguratecertain switches (Cisco...
Hi, I'am quite new to DMVPN but I'am used to the underlying technologies in use (GRE, IPSEC, etc...).I'am trying to deploy it for the first time but I'am running into an issue and I couldn't find the solution. The topology is as followed (simplified)...
Selecting the proper lab training platform is fundamental to preparing for CCNA certification. Cisco CCNA is a foundational networking certification that requires knowledge of IOS configuration of multiple protocols. So where do you start and what la...
Resolved! 802.1x authentication behaviour ?
Hello, we have 802.1x configured on numerous 2960 switches. We have a primary and secondary RADIUS server configured. My question is, what happens if:i) the primary RADIUS server is reachable but the shared secret fails i.e. will it fail over to auth...
Let me understand what is difference between NX-OS, IOS XE & IOS XR
We are running dynamic NAT and ZBF on cisco router but guest wifi users always have connection issues, i mean they can connect to wifi but unable to access internet and every time i have to clear NAT translations so the internet gets connected, follo...
Hello, I'm migrating from using an ASA5506-X firewall to Firepower 1010 running ASA code. The ASA was able to create multiple L2L ipsec tunnels using IKEv2. Running the same config on the Firepower, I'm only able to create one connection at a time....
When I open any networking device such as switch or router, it opens in full screen in a new tab by default. it just feels so annoying every time to resize it smaller.
Is it possible to change the color scheme in Cisco Network Assistant? The Topology View screen is very hard to read. Thanks, Rick
Hi everyone, I am trying to set up priority queuing on ASA to prioritize voice traffic within my network but I cannot figure out what values should be put for queue-limit and tx-ring-limit. I read the below documentation but still cannot figure out h...
Hi, We installed a new Server UCS C240 M4 in our data Center and connected to SAN Storage switch(Cisco MDS 9124) but Link between UCS C240 M4 Server and MDS 9124 Switch is not becoming up. Models for Two SFPs on Server are SFP-10G-SR and SW 4X FC TRA...
