Other Network Architecture Subjects

Hello experts, I have some general question about what design would you recommend for the scenario below. I advised company to replace their current 4 switches (from 3 different brands and quite old ones) with a 2x Catalyst 2960X-48FPD-L and put them...

I purchased cisco virl yesterday and was testing a lab on it. I noticed that I couldn't save configs on the fly. for example, I was testing HSRP configurations and proceeded to test the failover to the other peer in the group by shutting down the pri...

Hello dear members,I'm working on a Packet Tracer project, and i'm experiencing an issue with Telnet from one of the Pc's to the Server.I get the prompt "Connection refused by remote host". This is the Packet Tracer file i'm working with is this: htt...

After reading Cisco's documentation (http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/sw_cfg/stp_enha.htm)I'm confused - when does one use Backbone Fast as opposed to Uplink Fast ?Seems to me that they both do the same thing. I h...

I have 2611 unit with 2 flash partitionI would like to remove these partitions and make one complete partition of 16MBHave try to erase flash:1 and 2rommon tftpdnld but now it goes to only one partion with 8MB!Pls provide help.Appreciated!!1)8192K by...

I have an http server on which I uploaded a JPG image of 8431 bytes.An host downloads that image, through its web browser.Following the simulation in Packet tracer, I observe a download traffic of 22 TCP segments:the first 21 segments with a payload ...

um so i think im doing everything right, I connected them right, I gave each pc/laptop/server ip address and default gateway address, with which they are connected to router (as you can see in photo) I can send message from pc1 to laptop1 but i cant ...

Hi All, I'm planning to use a ASR 1009-X router with 40Gbit connections (80Gbit throughput) and I would like to know whether any performance licenses are needed?Also do you know any documentation regarding the Cisco licensing? What kind of possible l...

We are a financial company and we have all our workloads hosted in our office currently. This includes esxi hosts, financial feeds and telephone systems. At the moment we are on single floor we have two Catalyst 6808 VSS in active standby mode as cor...

I am stumped by some sort of routing problem.  Any assistance is appreciated!I have several Meraki Cameras in a remote site that are currently in VLAN 1.I need to move the cameras into a dedicated VLAN (VLAN 300). When I move a camera into VLAN 300 I...

Hello Experts, I could able to see many route-map when I give command sh route-map in CLI, but when I tried to see the running config I could able to see only 2 route-map that are bind to the BGP neighbor.  Is there any command to check where the rou...

Currently I have a single fiber connection connecting two organizations/networks using VLAN interface (SVI) and static routing. Switchs involved happen to be Nexus switches from both organizations. Two networks are independant and have their own Inte...