Boot from rommon mode

[lzakariya]

Hi...

I have a serious issue...My WAN router was crashed after a power failure. When I restart the router it is directly going to rommon mode..

I run the following commands:

rommon 2 > confreg

rommon 3 > reset

rommon 1 > dir flash:

rommon 2 > boot flash:imgname.bin

But still its showing the software is crashed and again going to rommon mode. 
What can be problem? Is it the problem with flash. But I can all the required files inside flash

[mfurnival]

Can you post the log showing your router trying to load the IOS image and crashing please? You might have a corrupted image - you could try reloading the image via TFTP.

[Leo Laohoo]

Post the entire bootup process.  Your router could have a hardware failure.

[lzakariya]

I cannot access the router through console too. How can I check the logs and bootup process. I think its hardware crash.

[mfurnival]

You must be accessing the router through the console or you would not be able to do the rommon stuff

[paolo bevilacqua]

No router type mentioned. No complete boot log. No help possible.