Can cisco 2600 NM-8AM module support dedicated line ?

[luanwc]

Our customer want to use a Modem to connect to Cisco 2600 with NM-8AM module via a dedicated line (two copper line ) , I don't know how can It support this kind of connected-mode and how to configure the Modem on the router ? thanks.

[tepatel]

YES..2600 with NM-8AM does support 2 wire leased leased or dedicated line on modems. Here is the url which talks about configuring it.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/dtlealin.htm

[luanwc]

YES, I see the url. But I don't know if 8AM can support the 2 wire line connected directly without loop current ? or how can I supply the loop current for the 2 wire line ? Because the 2 wire line is set by customer by themselves.