Cat 3750- Stackable

[gilson_machado]

doe anyone has a config sample for the Cat3750 stack switches. Is tehr any special command to determine the primary switch?

Thanks

[Prashanth Krishnappa]

If you are looking to find the master switch, you can do the sh switch command

Switch#sh switch detail

Current

Switch# Role Mac Address Priority State

--------------------------------------------------------

1 Slave 000c.30ae.2300 1 Ready

*2 Master 000c.30ae.3d80 15 Ready

Stack Port Status Neighbors

Switch# Port 1 Port 2 Port 1 Port 2

--------------------------------------------------------

1 Ok Ok 2 2

2 Ok Ok 1 1

[shovels3]

If you want to set one of the switched as the Master Switch then use the command

Switch(config)#switch 1 priority ?

<1-15> Switch Priority

? is the priority you want to give the switch

if you set a high priority on the switch this will always be your master switch when it's in the stack

[gilson_machado]

Thank you the command you sent is very usefull.

I have 3 in stack. Is there any command that you can determine if you are connected to the console of Switch 1 ,2 or 3 ?

[gilson_machado]

Thanks for the command. Is ther any way to determine in whihc switch I am connected via console?