04-11-2003 02:32 AM - edited 03-02-2019 06:35 AM
my cat 4006 got hanged . when taking the sh tech support i found the following. and after restarting it showed ok. given below is sh epc status before and after restart.
Before restart *****
------------------ show epc status ------------------
Status of GigabitEthernet1: OK
Status of GigabitEthernet2: OK
Status of GigabitEthernet3: OK
Status of GigabitEthernet4: not OK - aborting this command
After Restart *****
B_4006_L3#sh epc status
Status of GigabitEthernet1: OK
Status of GigabitEthernet2: OK
Status of GigabitEthernet3: OK
Status of GigabitEthernet4: OK
can any one explain..
thanks
Solved! Go to Solution.
04-11-2003 04:31 AM
It normally indicates bad hardware but looks like it came back in your case. Make sure the card is seated firmly and if it happens again, open a TAC case
04-11-2003 04:31 AM
It normally indicates bad hardware but looks like it came back in your case. Make sure the card is seated firmly and if it happens again, open a TAC case
04-14-2003 11:23 PM
suspecting the problem with the RSM module.
RMA raised.
replaced the RSM card. network performing normal.
thanks a lot.
rajendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide