cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
715
Views
0
Helpful
2
Replies

Cat6800 VSS not stablished

Heriberto Diaz
Level 1
Level 1

Hi

 

Preventive maintenance is performed on the equipment, when it was turned on again, the VSS was not established, the configuration was checked and everything is fine.


So the switch "standby" was turned off and the cards were removed leaving only the supervisor card, it was turned on again and the VSS was established.

 

Does anyone know why this happened?

CAT6800

ios: s2t54-adventerprisek9-mz.SPA.151-2.SY6.bin

Supervisor: VS-SUP2T-10G

 

Regards.

 

 

2 Replies 2

balaji.bandi
Hall of Fame
Hall of Fame

The information was provided not Enough to tell what was went wrong.

 

1. First place i will check the log message, when it was not formed VSS, i am sure you get enough logs what went wrong and produces logs.

2. What is the cards you referring that were removed and formed VSS.

3. Are you using any of the Line cards or VSL links ?

4. how is your Access Switches connected to VSS, using L3 or L2 ?

 

Couple of output to help the community.

 

show switch virtual

show switch virtual role

sh switch virtual dual-ac su

show switch virtual redundancy 

show switch virtual link

Show module switch all 

 

 

Post the VSS config to understand what interfaces configured.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Leo Laohoo
Hall of Fame
Hall of Fame
I agree.
If there was something wrong, it would be appearing in the logs.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: