catalyst cluster

[Przemyslaw.Agacinski]

I have two catalyst C2950SX-48-SI configured in cluster with one IP address using CLI. Now I wish to manage them by Cisco Network Assistant but only command switch is seen in gui, no member switch. How can I managed all switches in cluster using CNA ?

[Georg Pauwen]

Hello,

not knowing exactly where you get stuck, you might want to have a look at this document, check the section that describes the various cluster member discovery ways:

Getting Started with Cisco Network Assistant

Planning and Creating Clusters

http://www.cisco.com/en/US/products/ps5931/products_getting_started_guide_chapter09186a00802b7d99.html

HTH,

GP

[Przemyslaw.Agacinski]

Thank you Georg , but my CNA is 3.0 version and there is no exists “Cluster” option in menu. In CNA topology view there are only devices with assigned IP addresses but no cluster members (without IP). I can configure cluster using CLI and it is working fine.

PA