10-24-2005 04:10 AM - edited 03-03-2019 12:32 AM
I have two catalyst C2950SX-48-SI configured in cluster with one IP address using CLI. Now I wish to manage them by Cisco Network Assistant but only command switch is seen in gui, no member switch. How can I managed all switches in cluster using CNA ?
10-24-2005 09:50 PM
Hello,
not knowing exactly where you get stuck, you might want to have a look at this document, check the section that describes the various cluster member discovery ways:
Getting Started with Cisco Network Assistant
Planning and Creating Clusters
HTH,
GP
10-25-2005 02:58 AM
Thank you Georg , but my CNA is 3.0 version and there is no exists Cluster option in menu. In CNA topology view there are only devices with assigned IP addresses but no cluster members (without IP). I can configure cluster using CLI and it is working fine.
PA
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide