Cisco 2110 - HA with Dual ISPs

[SedricCaldwell91563]

Looking for some guidance around the following setup:

We have two Cisco NGFW 2210 (running 6.6), and also have two ISPs (Comcast and AT&T).  The HA pair are being managed by FDM (with no intentions of using FMC).  

I have not seen any documentation that supports an active-active configuration based on current version (v6.6).  

Has anyone setup these appliances with active-standby with FW1 (ISP1 + FW2 (ISP2).

[balaji.bandi]

FW1 (ISP1 + FW2 (ISP2).  - no this is not possible high level - until you make them standalone mode

but you can do PBR to route the traffic to ISP1 and ISP2 to split the load between 2 ISP - is this works for you below guide help you :

https://www.youtube.com/watch?v=MKcSBTJ55e8&t=18s

[MHM Cisco World]

https://www.cisco.com/c/en/us/support/docs/security/firepower-management-center/212699-configure-ftd-high-availability-on-firep.html

[HaniAbuelkhair6735]

I don't think this is possible as i have the same issue with my FP1010 (running 6.6), and also have two ISPs. if you have FTD managed by FDM (with no intentions of using FMC).  

This is Cisco Bug note 

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvb19682/?rfs=iqvred

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvo39894

This doesn't make sense at all to have a limitation for Dual ISP Load balance and failover, 

Using Cisco its really strange 

if you have any other suggestion please advise 

[balaji.bandi]

I know FDM has limited features, only to manage certain features, For full working featured cisco suggesting FMC requirement.