07-30-2006 06:40 PM - edited 03-03-2019 04:17 AM
Cisco 6509-E with two SUP720 in my environment I would like to achieve
Active / Active with load sharing between the two SUP720, can this be implemented, please advice on configuration.
07-30-2006 10:06 PM
Hi
AFAIK, When you are using 2 MSFCs only one of them would be active and the other would compulsorily in standby mode. So I dont think you would be able to configure active/active configuration.
Refer the following link for detailed instructions on configuring Redundancy using Dual MSFCs:
Hope this helps.
Regards,
AbhisheK
Please rate all posts!!!
08-08-2006 08:30 AM
Could you just disable redunancy and therefore place them in active/active? You would then have to work your routing metric to your upstream device to achieve your load balancing strategy.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide