Cisco 678 ADSL migration to Cisco 1417 ADSL

[fsebera]

I have a Cisco 678 ADSL router provided by my ISP. The ISP has given me login access to the local Cisco 678 router.

I would like to switch out the Cisco 678 NON-IOS router with a Cisco 1417 IOS enabled router.

I cannot get the ADSL (ATM0) line to EVER come up, it's always DOWN/DOWN.

I have configured the VPI/VCI (0/35). When I run debug atm commands I get the 0x8 status message and the line always is down/down.

ANY help would be appreciated.

I am running static IP, and do not use PPoE.

The ISP tech tells me the Cisco 1417 MUST support DMT, CAP or G.Lite encoding and RFC1483 routing.

Thank you.

[Georg Pauwen]

Hello,

can you post the configuration of your 1417 ? Also, which IOS version are you running ?

Not sure if you have already looked at this document, it talks about Layer 1 troubleshooting on the 1417:

ADSL

Troubleshooting Layer 1 on a Cisco 1417 Router

http://www.cisco.com/en/US/partner/tech/tk175/tk15/technologies_problem_troubleshooting09186a0080093c25.shtml

Regards,

GP

[fsebera]

Thanks for the troubleshooting doc

Here is the configuration on the Cisco 678

DSL-678#sh running

Warning: traffic may pause while NVRAM is being accessed

[[ CBOS = Section Start ]]

NSOS 1483 Routing = enabled

NSOS Strict Exec Password =

NSOS MD5 Root Password =

NSOS MD5 Commander Password =

NSOS Ethernet Speed = autodetect

NSOS MD5 Enable Password =

NSOS Prompt = DSL-678

[[ TFTP = Section Start ]]

[[ IP Routing = Section Start ]]

IP NAT Outside IP = 61.036.159.209

IP NAT Entry = 192.168.1.1, 23, 61.036.159.209, 23, tcp;

IP Port Address = 00, 61.36.159.209

IP Port Address Mask = 00, 255.255.255.248

IP Directed_Broadcast Forwarding = disabled

[[ ATM WAN Device Driver = Section Start ]]

ATM WAN Virtual Connection Parms = 00, 0, 35, 0

[[ SNMP Management = Section Start ]]

SNMP = enabled

SNMP Manager List = 61.36.159.210, publice, read, trappable, all;0.0.0.1, private, write, trappable, all;0.0.0.0, publice, read, trappable, all;

[[ DHCP = Section Start ]]

DHCP Server = enabled

DHCP Server Learn First Pool Address = enabled

DHCP Server Pool DNS = 00, 26.18.103.205

DHCP Server Pool Secondary DNS = 00, 166.79.035.242

DHCP Server Pool Lease = 00, 43200

DHCP Server Pool = 00, disabled

[[ WEB = Section Start ]]

[[ SYSLOG = Section Start ]]

SYSLOG = enabled

SYSLOG Server = 61.36.159.210

The configuration on the Cisco 1417 is blank so far.

Tks