Hi,
I have a Cisco 7206 VXR router with NPE 300 processor. I was trying to replace the existing 16MB PCMCIA card in the I/O controller PCMCIA slot with a new 48MB Flash disk to accomodate a 12.2(T) image but I am unable to format the new Flash disk. Upon entering the command "format slot0:" it prompts me for a Volume label number. Is this normal?
I also noticed that upon doing a "show version" command, the router didn't seem to recognize the new Flash disk, instead it displayed
"0Kb of memory, PCMCIA card"
Please advise.
Thanks,
RAJ