Hi ,
I would like to know the step by step configuration of NP-CE1B in Cisco 4500 router. I tried in cco.cisco.com. Any help in this regard would be highly appreciated.
The equipments what I have are Cisco4500 router with NP-CE1B module, where the channelized E1 is terminated, and is kept at the central location. Now I want to take 256kbps to one location and 128kbps to another location. At location one, what I have is four 64kbps lines terminated in four serial port of Cisco4500. And at second location I have two 64kbps lines terminated in the serial ports of Cisco 4500.
My requirement is, I want to configure time slots 1,2,3and 4 as group0 for location one and time slot 5,6 for location 2.
Router(config-controller)# channel-group 0 timeslots 1-4
Is the above step is correct???
Also I want to assign IP address for the above logical interface
How can I do that...
Is it possible for to treat this logical interface like a Serial intercae.
How can I do the ip routing to this logical interface??
