Configure a WIC for primary

[pgasol]

Hello, i must configure a 2610 with IOS 12.2(8)T that have a WIC 1MTF-G703 to receive incoming calls, but I no have idea.

Can anybody help me, please?

[rlcarr]

What kind of calls are you trying to receive?

Voice, data, analog, digital, .....

is this over a T1, or a PRI ....

is it supposed to forward to a PBX, internal modems, .....

~rlc

CCNP, CCDA, CNE

[tepatel]

You can receive the incoming voice calls over that VWIC-1MFT-G703, which is 1-Port RJ-48 Multiflex Trunk - E1 for unstructured G.703, from PSTN.

Here is the link which talks about the features supported on that card

http://www.cisco.com/warp/public/788/products/vwicmf_e1.html

Here is the link which explains how to configure that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t7/t1_mf_t6.htm

After that depending on the network setup, you need to configure dial-peers etc For that here is the link which will help you for that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113t/113t_1/voip/examples.htm