01-21-2004 12:58 PM - edited 03-02-2019 01:04 PM
I'm needing to create an uplink port on a c2924xl. Can anyone point me to the correct documenation.
Thanks in advance
01-21-2004 03:51 PM
There is no special configuration needed. If it is just one VLAN, assign the interface to whatever VLAN you want. If you want it to be a trunk, configure trunking under the interface. You can find some config examples at
01-26-2004 07:45 AM
The problem is that I don't have a VLAN setup. I have recently inheraited this network and I have 2 Netgear switchs, 2 Linksys switchs, 1 Cisco Hub (400 series) and 1 Cisco 2900 switch. I'm trying to add a new 2900 switch and I'm not sure how to setup one of the ports as uplink.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide