cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6589
Views
5
Helpful
8
Replies

Disable CISCO-GENERAL-TRAPS "TcpConnectionClose".1.3.6.1.4.1.9.0.1

kwengenfu
Level 1
Level 1

I want to disable this trap for 3550 , but what is the command ? I try to use the following command but failed

no snmp-server enable traps

Any suggestion ?

1 Accepted Solution

Accepted Solutions

milan.kulik
Level 10
Level 10

Hi,

I think they are sent by

snmp-server host .... tty

command.

Regards,

Milan

View solution in original post

8 Replies 8

milan.kulik
Level 10
Level 10

Hi,

I think they are sent by

snmp-server host .... tty

command.

Regards,

Milan

Yes, Thanks for your help, command is

for 3550 (Ommit tty, syslog)

snmp-server host A.B.C.D bgp bridge cluster config copy-config entity envmon flash hsrp mac-notification port-security rtr snmp stpx vlan-membership vlancreate vlandelete vtp

for 35XX, 29XX(Ommit tty, syslog)

snmp-server host A.B.C.D bridge c2900 cluster config entity hsrp mac-notification snmp vlan-membership vtp

rmushtaq
Level 8
Level 8

Does "no snmp-server enable traps tty" help?

Thanks,

do not support "tty" and "x25" .

For More Info, see "Cisco IOS SNMP Traps Supported and How to Configure Them"

where do you see this traps, on LMS or NNM? If its NNM its probably esieast to set them to "dont`t log or display"