error message on cat6500 and cat4000

[wingkui_l]

Dear all,

I've received some error messgae from cat 6509 and cat4000. I have try to search with "error message decoder" but no result found. Would anyone please help me to find out what is the meaning of these system message. Thanks a lot

Cisco C6500 msg:

%CATD_I_066, Link down: Communication link failed on interface #183

%CATD_I_066, clogMessageGenerated: clogHistFacility: ETHC, clogHistSeverity: 6, clogHistMsgName: ETHC, clogHistMsgText: 2005 Aug 10 09:51:26 %ETHC-5-PORTFROMSTP:Port 2/29 left bridge port 2/29,

Cisco4000 msg:

%CATD_I_066, Link down: Communication link failed on interface #20

%CATD_I_066, clogMessageGenerated: clogHistFacility: CDP, clogHistSeverity: 5, clogHistMsgName: DUPLEX_MISMATCH, clogHistMsgText: duplex mismatch discovered on FastEthernet3/2 (not full duplex), with Switch FastEthernet0/25 (full duplex).,

%CATD_I_066, clogMessageGenerated: clogHistFacility: C4K_EBM, clogHistSeverity: 5, clogHistMsgName: HOSTFLAPPING, clogHistMsgText: Host 02:01:00:00:00:00 in vlan 5 is flapping between port Po1 and port Fa2/15

[Mark Turpin]

CDP can be fairly chatty when there is a duplex mismatch.

Try fixing your mismatch and see what happens.

[wingkui_l]

thanks I will try to correct it and reply here later...but would you mind to tell me, do you have any idea with "%CATD_I_066," this message, as it appear offerly..

[Mark Turpin]

No idea, and google doesn't know either. You'll need a TAC case to find the answer most likely...

I'd say its probably just the switch throttling the CDP messages. You could also try turning on logging rate limiting to see if it helps.

hth,

-Mark