I have set 4 Gigabit trunks between two SW6509. I have set port channel mode on for all 4 on both switches. When I issue a show port channel command I am getting two different channels for each pari of trunks (like below). Is that OK? Why the 4 ports does not show as one channel ID? Are they bundle the speeds?
Looks like they broke up into 2 separate etherchannels. Try the following on both switches(note that I am using desirable versus ON mode since it is preferred)
set port channel 3/11-12 off
set port channel 3/13-14 off
set port channel 3/11-14 desirable
Learn, share, save
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
