cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
253
Views
0
Helpful
1
Replies

fabric enable problem...

jaejun-lee
Level 1
Level 1

Hi!

WS-X6248-RJ-45(Slot 1) Module does not appear in "Sh Faric Status Command".

Is it normally this? or not?

IC_2F_K_CL3MAIN_S#sh fabric status

slot channel speed module fabric

status status

2 0 20G OK OK

3 0 20G OK OK

7 0 20G OK OK

8 0 8G OK OK

IC_2F_K_CL3MAIN_S#sh mod

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 48 48 port 10/100 mb RJ-45 ethernet WS-X6248-RJ-45 SAD03290934

2 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL08424ZCL

3 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL08414SHZ

7 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAD083905JH

8 2 Supervisor Engine 720 (Hot) WS-SUP720-BASE SAD083900SW

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

1 00d0.d39a.e698 to 00d0.d39a.e6c7 1.1 4.2(0.24)VAI 8.3(0.110)TE Ok

2 0012.005c.618c to 0012.005c.61a3 2.1 12.2(14r)S5 12.2(17d)SXB Ok

3 0012.0092.f464 to 0012.0092.f47b 2.1 12.2(14r)S5 12.2(17d)SXB Ok

7 0011.21ba.6a48 to 0011.21ba.6a4b 3.1 8.1(3) 12.2(17d)SXB Ok

8 0011.21b9.ad44 to 0011.21b9.ad47 3.1 8.1(3) 12.2(17d)SXB Ok

Mod Sub-Module Model Serial Hw Status

--- --------------------------- ------------------ ------------ ------- -------

2 Centralized Forwarding Card WS-F6700-CFC SAL08353658 2.0 Ok

3 Centralized Forwarding Card WS-F6700-CFC SAL08321MUP 2.0 Ok

7 Policy Feature Card 3 WS-F6K-PFC3A SAD08290B6N 2.4 Ok

7 MSFC3 Daughterboard WS-SUP720 SAD083702CC 2.3 Ok

8 Policy Feature Card 3 WS-F6K-PFC3A SAD083607RM 2.4 Ok

8 MSFC3 Daughterboard WS-SUP720 SAD083801P3 2.3 Ok

Mod Online Diag Status

--- -------------------

1 Pass

2 Pass

3 Pass

7 Pass

8 Pass

thank you

1 Reply 1

Prashanth Krishnappa
Cisco Employee
Cisco Employee

It is normal. WS-X6248-RJ-45 is not a fabric enabled card but a classic card which has "bus" only connections. Hence, you do not see it in the output of sh fabric status.

Hope this helps.