We use GRE tunnels to transport frame relay traffic between two Lucent frame relay switches. Tunnel traffic is routed over the public Internet. Looking for a method to let the router create an event when the tunnel isn't complete. For example, when one tunnel destination becomes unavailable, no events are generated into the log.
I also am searching for some tool that would monitor for packet loss between the tunnel destination IP's and possbly put the tunnel out of service until the packet loss returns to normal.
Below is an example of our configuration:
=Router 1=
interface Tunnel0
description TUNNEL to Router 2
ip address 10.0.0.1 255.255.255.0
tunnel source Serial2/0
tunnel destination 200.x.x.125
interface Serial2/0
description IP Tunnel to Router 2
bandwidth 4096
ip address 216.x.x.221 255.255.255.252
encapsulation frame-relay IETF
serial restart_delay 0
frame-relay lmi-type q933a
frame-relay intf-type dce
frame-relay route 900 interface Tunnel0 900
=Router 2=
interface Tunnel0
description TUNNEL to Router 1
ip address 10.0.0.2 255.255.255.0
tunnel source Serial1/0
tunnel destination 216.x.x.221
interface Serial1/0
description IP Tunnel to Router 1
bandwidth 4096
ip address 200.x.x.125 255.255.255.252
encapsulation frame-relay IETF
serial restart_delay 0
frame-relay lmi-type q933a
frame-relay intf-type dce
frame-relay route 900 interface Tunnel0 900
Thanks, for any suggestions