09-05-2006 02:54 AM - edited 03-03-2019 04:49 AM
dear sir,
i want to enable snmp in cat 4006 for ciscoworks lms 2.2.please suggest.
09-05-2006 02:59 AM
mukhtar,
you can refer to the following document:
http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_guide_chapter09186a00800915d0.html
you need to define the community strings and configure the same on the LMS 2.2 box to capture the inventory, software, configuration etc....
Hope this helps.. all the best.. rate replies if found useful..
Raj
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
