08-19-2002 12:19 AM - edited 03-02-2019 12:45 AM
The Document indicate that the ios version 12.11b.ew1 can support mutiple vlan access port on 4006,but we can not config in fastethernet interface,anyone konw about it?
08-19-2002 04:27 AM
Sup3 does not support multi-vlan ports. Can you point us to the documentation. However you can configure a port to be a trunk. Trunks carry the traffic of multiple VLANs over a single link and allow you to extend VLANs
across an entire network.
http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/config/layer2.htm
08-19-2002 07:40 AM
Thanks for you reply,the documentation point to the multiple vlan access point in Release 12.1(11b)EW was at http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_18a/ol_2170.htm#xtocid10
pls see the new software feature item for 12.1(11b)ew.The config of trunking in server must be confirm first that the server support it. BTW,if we use inter-vlan routing,how do we filter so unwanted router?
08-19-2002 08:08 AM
I believe that this the multi-VLAN concept is for voice VLANs only
http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/config/voice.htm#xtocid1
If your server NIC is capable of trunking, you can configure the switchport to trunk
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide