12-31-2003 10:00 AM - edited 03-02-2019 12:37 PM
I have 4 routers in my Frame Relay WAN configured in Hub and Spoke. All routers can see each other, in fact all networks can see each other (I'm running EIGRP). The Hub router in Corporate connects through a Check Point Firewall and out to the internet. The remote routers are suppose to take the same path to the internet. Each router reports "destination host unreachable" only when trying to get to the internet but works fine between the offices. WHAT DID I FORGET??
12-31-2003 11:30 AM
Is the hub router forwarding a default route to the other routers?
Mark
12-31-2003 11:40 AM
The hub router has a default gateway on the lan side (which is the firewall) All devices in the hub location has this DG. The remote routers do not have a DG set but are the DG for thier respective networks. Office to office connectivity works fine. All servers are at the hub location and all isers can login, get email, etc.
12-31-2003 11:55 AM
The spokes need a default gateway pointing to the hub. Otherwise they dont know where to send packets for all those "unknown" destination networks on the internet. Most of the time the default is all they need.
12-31-2003 01:05 PM
Thanks,
I'll give it a shot.
01-02-2004 10:14 AM
I'm guessing that your using static routing to the Internet from the main router, you could easily accomplish this by redistributing your static routes on the main router into your EIGRP tables... Should be something like:
router eigrp 1
redistribute static
This can have other consequences too if you have more than just the static route for the Internet on that router.
01-03-2004 12:31 PM
Does the f/wall know the route back to the spoke sites
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide