03-30-2012 07:55 AM - edited 03-03-2019 06:31 AM
Am looking at a problem with servers in the same vlan across multiple switches that are unable to communicate using multicast. I have found that in the systen I'm to set up I need to apply the ip igmp snooping querier command, in the vlan, but it needs a source IP address.
Different documents make conflicting recommendations for this address, one suggests that any unused address will do, another suggests to use the IP address that is configured on the SVI for the vlan.
Which is correct?
04-06-2012 08:02 AM
Eventually I had to ask Cisco TAC, the response was that any IP address within the subnet could be used. The recommendation was to allocate an unused address in the vlan subnet for this purpose, use the same address on multiple switches should resiliance be required.
06-17-2015 12:35 PM
Hi guys.
Yesterday I've the same issue with nexus 5596. L2 Multicast on the same Switch and olny Layer2 is the role of this Switch. After apply the following commands the problem has been solved.
config
vlan configuration 2616
ip igmp snooping querier 172.16.239.5
end
The ip address needs to be any free ip address on the same subnet/vlan.
I hope it helps you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide