cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
457
Views
0
Helpful
1
Replies

IP PRECEDENCE

Hi all,

I have the following conf on my router:

class-map match-all NBAR_NTP
match protocol ntp
class-map match-all NBAR_DNS
match protocol dns

policy-map DNS_PREC
class NBAR_DNS
set ip precedence 4
class NBAR_NTP
set ip precedence 3

The policy is applied to the interface where the server is connected:

interface FastEthernet0
no ip address
load-interval 30
service-policy input DNS_PREC
hold-queue 1000 in
hold-queue 1000 out

But when I check the stats no one packet seems to be marked by the policy-map

887VA#show policy-map interface fastEthernet 0
FastEthernet0

Service-policy input: DNS_PREC

Class-map: NBAR_DNS (match-all)
0 packets, 0 bytes
30 second offered rate 0000 bps, drop rate 0000 bps
Match: protocol dns
QoS Set
precedence 4
Packets marked 0

I' m not expert in QoS. What is wrong with my configuration? What I' m trying to achieve is to give priority to the DNS traffic and NTP traffic. Is it the right procedure to do it?

Thanks

1 Reply 1

Ok,

Mybe I have figured out by myself.

My router is cisco 887 and the 4 fastethernet are under vlan 1 interface. If I apply the policy to the interface vlan, I can see the packet get marked.

Vlan1

Service-policy input: DNS_PREC

Class-map: NBAR_DNS (match-all)
981 packets, 94954 bytes
5 minute offered rate 2000 bps, drop rate 0000 bps
Match: protocol dns
QoS Set
precedence 4
Packets marked 981

Now, one question remain: is it the right conf for what I'm looking for?

The setup is the following:

ADSL---CISCO887---FIREWALL---SERVER

The DNS and NTP traffic is biderectional. The policy that I have applied is it enough in order to prioritize the traffic?

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers