Hi,
We are usign the following MIB variable in order to obtain the current bandwith:
.1.3.6.1.2.1.2.2.1.5
ifSpeed OBJECT-TYPE
-- FROM RFC1213-MIB, IF-MIB
SYNTAX Gauge
MAX-ACCESS read-only
STATUS Mandatory
DESCRIPTION "An estimate of the interface's current bandwidth in bits per second. For interfaces which do not vary in bandwidth or for those where no accurate estimation can be made, this object should
contain the nominal bandwidth."
::= { ISO(1) org(3) DOD(6) Internet(1) mgmt(2) mib-2(1) interfaces(2) ifTable(2) ifEntry(1) 5 }
When we put the command "bandwidth" on the serial interfaces, does it create any MIB variable or is there any one that corresponds to it?
What is the MIB variable that could tell us about the PVC bandwith?