cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
197
Views
0
Helpful
1
Replies

Is there any MIB variable for the informational parameter "bandwidth"?

arlopez
Beginner
Beginner

Hi,

We are usign the following MIB variable in order to obtain the current bandwith:

.1.3.6.1.2.1.2.2.1.5

ifSpeed OBJECT-TYPE

-- FROM RFC1213-MIB, IF-MIB

SYNTAX Gauge

MAX-ACCESS read-only

STATUS Mandatory

DESCRIPTION "An estimate of the interface's current bandwidth in bits per second. For interfaces which do not vary in bandwidth or for those where no accurate estimation can be made, this object should

contain the nominal bandwidth."

::= { ISO(1) org(3) DOD(6) Internet(1) mgmt(2) mib-2(1) interfaces(2) ifTable(2) ifEntry(1) 5 }

When we put the command "bandwidth" on the serial interfaces, does it create any MIB variable or is there any one that corresponds to it?

What is the MIB variable that could tell us about the PVC bandwith?

1 Reply 1
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers