Greetings,
I have two 2500 series routers with BRI/NT1. I am trying to set them up in a lab scenario using a Emutel ISDN switch simulator. Everything looks good up through layer 2. When I try and ping the other the remote side I get:
%SYS-5-CONFIG_I: Configured from console by console
ISDN BR0: TX -> SETUP pd = 8 callref = 0x01
Bearer Capability i = 0x8890
Channel ID i = 0x83
Keypad Facility i = '3840000'
ISDN BR0: RX <- CALL_PROC pd = 8 callref = 0x81
Channel ID i = 0x89
Signal i = 0x05 - Confirm tone on
ISDN BR0: RX <- PROGRESS pd = 8 callref = 0x81
Cause i = 0x8092 - No user responding
Progress Ind i = 0x8088 - In-band info or appropriate now available
Signal i = 0x01 - Ring back tone on
ISDN BR0: RX <- DISCONNECT pd = 8 callref = 0x81
Cause i = 0x8092 - No user responding
Signal i = 0x03 - Network congestion tone on
ISDN BR0: TX -> RELEASE pd = 8 callref = 0x01
Cause i = 0x8090 - Normal call clearing
ISDN BR0: RX <- RELEASE_COMP pd = 8 callref = 0x81
Signal i = 0x3F - Tones off
The remote side get's:
%SYS-5-CONFIG_I: Configured from console by console
ISDN BR0: RX <- SETUP pd = 8 callref = 0x01
Bearer Capability i = 0x8890
Channel ID i = 0x89
Signal i = 0x40 - Alerting on - pattern 0
Calling Party Number i = 0x0083, '3840200'
Called Party Number i = 0x80, '3840000'
Locking Shift to Codeset 6
Codeset 6 IE 0x26 i = 0x0101
%LINK-3-UPDOWN: Interface BRI0:1, changed state to up
%ISDN-6-CONNECT: Interface BRI0:1 is now connected to 3840200
ISDN BR0: TX -> CONNECT pd = 8 callref = 0x81
ISDN BR0: RX <- RELEASE pd = 8 callref = 0x01
Cause i = 0x80E0 - Mandatory IE missing
Signal i = 0x4F - Alerting off
%LINK-3-UPDOWN: Interface BRI0:1, changed state to down
I have tried looking up this "Mandatory IE missing" with no luck. Anyone have any idea's?
Thanks.
