Hello,
I wanted to enable the logging event subif-link-status command on Cisco 7609 with Supervisor Engine 720 (WS-SUP720-3B) , but I read on Cisco site the following:
http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_l1.html#wp1024011
This command is not supported on Cisco 7600 series routers that are configured with a Supervisor Engine 720.
But I'm not sure of this as the Cisco 7609 allow to enable it:
(config-if)#logging event ?
bundle-status BUNDLE/UNBUNDLE messages
link-status UPDOWN and CHANGE messages
nfas-status NFAS D-channel status messages
spanning-tree Spanning-tree Interface events
status Spanning-tree state change messages
subif-link-status Sub-interface UPDOWN and CHANGE messages
trunk-status TRUNK status messages
May anyone help me?
Thanks.