cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
417
Views
0
Helpful
1
Replies

Logging level on a C2950-24

chatasos
Level 1
Level 1

The following is from a C2950-24:

%SPANTREE_FAST-7-PORT_FWD_UPLINK: VLAN0032 FastEthernet0/24 moved to Forwarding (UplinkFast).

And this is from a C2924-XL:

%SPANTREE_FAST-6-PORT_FWD_UPLINK: Port FastEthernet0/24 in vlan 9 moved to Forwarding (UplinkFast).

Is there a way to change the "spantree" logging level (in the C2950) from 7 to 6? I have "logging trap 6" on both switches, so level 7 messages aren't logged.

I know level 7 is meant for debug reasons, and i believe C2950 has it wrong, since this not a debug message. Of cource i can change the logging level of C2950 to 7 but that's not a right solution, since it should be used only for debug purposes.

1 Reply 1

jbayuka
Level 5
Level 5

I do not think that you can set debug levels feature wise on IOS based switches. It is possible only with the set based switches.

Review Cisco Networking for a $25 gift card