cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
238
Views
0
Helpful
2
Replies

Making two Switches work together at 100 MB

ccna
Beginner
Beginner

I have a cisco catalyst 2924 and a xyplex 10/100 Switch. I cannot get a device on one switch to talk to a device on the other switch at good speeds.. As long as they are on the same switch (either one) they do just fine. The switches are connected to each other via a cross over cable... Any ideas would be appreciated.

Thanks,

Dale

2 Replies 2

doug.lockwood
Beginner
Beginner

Three Ideas:

A Try another Crossover cable.

B Hard code both to 100 full.

C Download a copy of QCheck from netiq.com. Install it on several pc's and quantify "just fine" and "good speed". Then report the hard data.

Regards;

Doug

I bet turning off autonegotiation and fixing both devices at whatever speed and duplex will solve it.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: