I have a 2610xm, ios 12.2(8)t5 with 32mb ram. slot 0 is a built in network module with one FE and 2 isdn bri s/t wics. I need two more isdn bri s/t interfaces and to be able to bundle all four into one ppp multilink bundle (temporary fix to bandwidth issue).
Can i put an nm-2w card in slot 1 and two more isdn bri s/t wics in or an nm-4b-st-t=
I just want to make sure that there are no hardware limitations etc before i buy new hardware, it says that the 2600 only supports one network module but does that mean the built in one or one more in addition to the built in one.
any comments appreciated.
regards
mark
