cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
289
Views
0
Helpful
1
Replies

MGX8230 back - to -back

6jgodinez
Level 1
Level 1

Hi, Is there a way to connect two mgx 8230 back to back with the oc-3 pxm-1 port?

I'm trying to pass e1 traffic from one CESM E1 to other. This is the lab setup:

e1--cesm-mgx8230-pxm1 --- pxm1-mgx8230--cesm--e1

Thank you in advance.

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Review Cisco Networking for a $25 gift card