Missing Serial Interface

[preston]

Have a Cisco 1750, I plugged a t1 wic into it, and it doesn't show me the Serial interface in the config. Its just recognizing it. I pulled a spare wic out of another 1750 and same thing.

Do I need to do anything to get it to recognize the s0 interface?

[donewald]

Without knowing what IOS version you are running this is a guess...

Is it an IOS issue. The WIC-1T requires the following min release.

12.0(5)XQ, 12.0(7)T, 12.1(1)T, 12.1(1), 12.2(1), 12.2(2)T, 12.2(2)XH,

12.2(2)XJ, 12.2(8)YJ, 12.2(8)YL, 12.2(8)YM, 12.2(8)YN

Hope this helps,

Don

[preston]

I think I am ok with this one, c1700-y-mz.121-5.t6.bin If that doesn't work is there a place I can go to download a new one?

[c-henrich]

As far I know you have to configure the T1 controler before you can see and configure the Serial Interface.