cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
288
Views
0
Helpful
3
Replies

mls flow full

eap
Level 1
Level 1

Hi,

We have a 6509 that I applied the command, set mls flow full, to yesterday as suggested by the TAC article for looking for the Nachi worm. I want to get rid of that command but am not sure how. I like the IOS where to negate a command you simply say no and repeat the command. Not so with CatOS.

Any help would be appreciated,

Paula

3 Replies 3

Prashanth Krishnappa
Cisco Employee
Cisco Employee

If you do not have access lists on any MLS-RP, the default flow mask is destination flow. You can change it using command

Console (enable) set mls flow ?

destination Set flow type Destination only

destination-source Set flow type Destination and Source

full Set flow type Full

Console (enable) set mls flow destination

Configured IP flowmask is set to destination flow.

Thanks,

Is that a default setting because that command was not in our previous non-default configuration?

Paula

Yes