Multiple Span Ports

[msgulotta]

I have a Cat2948 running 5.5(2)with multiple vlans configured. I have 2 Intrusion detections systems that I would like to install on 2 of the vlans configured on this switch. Can I span one vlan to one span port and another vlan to a different span port?

[thisisshanky]

you can do that

[msgulotta]

How do I configure for multilple span ports?

Here is how I attempted:

kc0102-2948-08> (enable) sh span

Destination : Port 2/19

Admin Source : VLAN 949

Oper Source : Port 2/4-6,2/8,2/11,2/13-16,2/21,2/37-38,2/40-41,2/44,2/46-48

Direction : transmit/receive

Incoming Packets: disabled

Learning : enabled

--------------------------------------------

kc0102-2948-08> (enable) set span 989 2/36

2002 Feb 21 09:03:28 %PAGP-5-PORTFROMSTP:Port 2/19 left bridge port 2/19

Overwrote Port 2/36 to monitor transmit/receive traffic of VLAN 989

Incoming Packets disabled. Learning enabled.

kc0102-2948-08> (enable) sh span

Destination : Port 2/36

Admin Source : VLAN 989

Oper Source : Port 2/7,2/20,2/22,2/31-34

Direction : transmit/receive

Incoming Packets: disabled

Learning : enabled

--------------------------------------------

kc0102-2948-08> (enable) sh span

Destination : Port 2/36

Admin Source : VLAN 989

Oper Source : Port 2/7,2/20,2/22,2/31-34

Direction : transmit/receive

Incoming Packets: disabled

Learning : enabled

--------------------------------------------

kc0102-2948-08> (enable) set span 2002 Feb 21 09:03:43 %PAGP-5-PORTTOSTP:Port 2/

19 joined bridge port 2/19

kc0102-2948-08> (enable) sh span

Destination : Port 2/36

Admin Source : VLAN 989

Oper Source : Port 2/7,2/20,2/22,2/31-34

Direction : transmit/receive

Incoming Packets: disabled

Learning : enabled

--------------------------------------------

kc0102-2948-08> (enable) sh span

Destination : Port 2/36

Admin Source : VLAN 989

Oper Source : Port 2/7,2/20,2/22,2/31-34

Direction : transmit/receive

Incoming Packets: disabled

Learning : enabled

--------------------------------------------

kc0102-2948-08> (enable)

I configure a span for vlan 949 and then try to configure a span for vlan 989 but only the span for 989 shows up when you do a show span. This message appears:

Overwrote Port 2/36 to monitor transmit/receive traffic of VLAN 989

[msgulotta]

I failed to put the key word create at the end of my second span port configuration. Now both span configurations are active.