I need to run NAT on my AS5200 to translate some private IPs in the 10.0.1.0 range. From the Cisco docs available, I am not sure what will happen to traffic on my existing ethernet interface if I put the IP nat access lists on it. An example set-up from Cisco gives the following:
interface ethernet 1
ip address 10.10.20.1 255.255.255.0
ip nat inside
interface serial 0
ip address 172.16.10.64 255.255.255.0
ip nat outside
ip nat pool ovrld 172.16.10.1 172.16.10.1 prefix 24
ip nat inside source list 7 pool ovrld overload
access-list 7 permit 10.10.10.0 0.0.0.31
access-list 7 permit 10.10.20.0 0.0.0.31
I'd like to do the following:
NAT any ip in 10.0.1.0 255.255.255.0 range to just one real IP in my class C.
All privite IPs are currently routed to one IP in my Class C (the ethernet interface on a 2nd router)
What kind of NAT commands do I need to set up so my current traffic isn't affected and I only NAT the private IPs?