05-28-2002 12:35 PM - edited 03-01-2019 09:54 PM
Hi,
Has anyone gotten something like the "nat 0" command on a PIX to work on an MSFC? I'm trying to get specific traffic to pass from an inside interface to an outside interface without being natted.
Thanks in Advance,
Drew
05-28-2002 01:12 PM
the nat config on a pix is altogether different than nat in IOS.
First question, did you order the firewall feature set for the mfsc, I think
you need that first.
05-28-2002 01:17 PM
If you don't wish for your addresses to be NATed on IOS, just deny them from the access-list you use to define NAT.
ip nat inside source list 1 interface serial0 overload
access-list 1 deny 203.24.1.0 0.0.0.255
access-list 1 permit any
In this case, the network 203.24.1.0 will *not* be NATed, but will be routed. All other addresses will be NATed (PATed) to the IP address on serial 0.
Mick.
05-28-2002 03:05 PM
Thanks ! It work great !
Drew
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide