10-06-2022 06:25 AM
Can anyone point me to a resource to determine possible root causes of this error message:
%NHRP-3-PAKERROR: Received Error Indication code: loop detected(3),
10-06-2022 06:31 AM
are you config ip nhrp responder ?
10-06-2022 07:02 AM
No. We basically use NHRP in a DMVPN setup, 2 Cisco 1111 devices at the same site with tunnels sourced off Gig interfaces to the primary ISP
10-06-2022 07:34 AM
So your router C1111 is spoke,
I think the Hub is config ip nhrp responder
and since C1111 is spoke you must config same IP hub use as responder in ip nhrp nhs.
check this point
10-09-2022 12:27 PM
Hello,
can you post the full configs of the hub and the spoke routers ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: