OID

[nadeladel71]

Dear all ,
                We have ASA device with the following information :
                                                                              Machine Type : Cisco ASA 5550
                                                                              Operating System : 9.0(3)
                                                                              Serial Number: JMX1415L2VA
I'm trying to use the Custom MIB Poller to monitor the traffic Utilization of a VPN tunnel on a Cisco ASA .I've found the .following OID
.1.3.6.1.4.1.9.9.171.1.3.1.3  (The total number of octets received by all current and previous IPsec Phase-2 Tunnels.
This value is accumulated BEFORE determining whether or not the packet should be decompressed.
See also cipSecGlobalInOctWraps for the number of times this counter has wrapped.)

the problem is we have many ipsec tunnels and this OID will give total traffic of all these tunnel , but we want to know utilization for specific IPSEC
Tunnel with specific IP address , how we can determine it . please , support us urgent.

[Robert Hillcoat]

Which software are you using to monitor your statistics? If you use PRTG then you can just use the built in options which will monitor your individual tunnels. You can usually find them by auto discovery, once you discover them you can use the options within the sensor to choose what you want to monitor exactly. 

[nadeladel71]

Dear Robert , Thanks for your reply , i used Solarwinds and i don't know the method to determine for specific Remote ip address . can you help me ?

[Robert Hillcoat]

The best place to get your answer would be the Solarwinds THWACK community.